Back to opcode table

MULX — Unsigned Multiply Without Affecting Flags

Opcode/Instruction Op/En 64/32 -bit Mode CPUID Feature Flag Description

VEX.NDD.LZ.F2.0F38.W0 F6 /r

MULX r32a, r32b, r/m32

RVM V/V BMI2 Unsigned multiply of r/m32 with EDX without affecting arithmetic flags.

VEX.NDD.LZ.F2.0F38.W1 F6 /r

MULX r64a, r64b, r/m64

RVM V/N.E. BMI2 Unsigned multiply of r/m64 with RDX without affecting arithmetic flags.

Instruction Operand Encoding



Operand 1

ModRM:reg (w)

Operand 2

VEX.vvvv (w)

Operand 3

ModRM:r/m (r)

Operand 4

RDX/EDX is implied 64/32 bits



Performs an unsigned multiplication of the implicit source operand (EDX/RDX) and the specified source operand (the third operand) and stores the low half of the result in the second destination (second operand), the high half of the result in the first destination operand (first operand), without reading or writing the arithmetic flags. This enables efficient programming where the software can interleave add with carry operations and multiplications.

If the first and second operand are identical, it will contain the high half of the multiplication result.

This instruction is not supported in real mode and virtual-8086 mode. The operand size is always 32 bits if not in 64-bit mode. In 64-bit mode operand size 64 requires VEX.W1. VEX.W1 is ignored in non-64-bit modes. An attempt to execute this instruction with VEX.L not equal to 0 will cause #UD.


// DEST1: ModRM:reg
// DEST2: VEX.vvvv
IF (OperandSize = 32)
    SRC1 ← EDX;
    DEST2 ← (SRC1*SRC2)[31:0];
    DEST1 ← (SRC1*SRC2)[63:32];
    ELSE IF (OperandSize = 64)
    SRC1 ← RDX;
    DEST2 ← (SRC1*SRC2)[63:0];
    DEST1 ← (SRC1*SRC2)[127:64];

Flags Affected


Intel C/C++ Compiler Intrinsic Equivalent

Auto-generated from high-level language when possible.
unsigned int mulx_u32(unsigned int a, unsigned int b, unsigned int * hi);
unsigned __int64 mulx_u64(unsigned __int64 a, unsigned __int64 b, unsigned __int64 * hi);

SIMD Floating-Point Exceptions


Other Exceptions

See Section 2.5.1, “Exception Conditions for VEX-Encoded GPR Instructions”, Table 2-29; additionally

#UD If VEX.W = 1.